L298N motor driver board module

L298N motor drive board module L298 stepper motor DC smart car robot accessories drive
(มีสินค้าในไทยพร้อมจัดส่งทันที)

Motor Drive Module L298N
ขับมอเตอร์ได้ 2 ตัวแบบแยกอิสระ สามารถควบคุมความเร็วมอเตอร์ได้ ใช้ไฟ 5 โวลต์ สามารถรับไฟเข้า 7-35 โวลต์ได้ มีวงจรเรกูเลตในตัว ขับกระแสสูงสุดได้ไม่เกิน 2A
Motor Drive Module L298N
This module is integrated with a built-in 5V power.When the drive voltage is 7V-35V it can enable the onboard 5V logic power supply;afterthe power supplydont input voltage in the interface+5V power supplybut you can lead the 5V for external use.
when ENA enable IN1 IN2 control OUT1 OUT2
when ENB enable IN3 IN4 control OUT3 OUT4
Applied cases:
1 Driving stepper motor
The connection of driving a common 4 line 2 phase electric motor is shown in below figure
after enable ENA ENB
Input the following driving timing from IN1-IN4，then the speed and direction of the stepper
motor can be controlled
2 Driving DC motor
Because the module is drived by double H bridgeit can drive two motors simultaneously.
The connecting method is shown inbelow figure
after enable ENA ENB
You can imput the speed and direction of PWM signal drive motor 1 from IN1 IN2
You can imput the speed and direction of PWM signal drive motor 2 from IN1 IN2
The signal is shown in the figure




วงจรทดสอบใช้ battery 18650 lithium 2 ก้อน code test: Motor AB วิ่งหน้าหลัง สลับกัน
Code basic:
//----------------------------------------------------------------------------------------------- int IN1 = 4;
int IN2 = 5;
int IN3 = 6;
int IN4 = 7;

void setup()
{

pinMode(IN1 OUTPUT);
pinMode(IN2 OUTPUT);
pinMode(IN3 OUTPUT);
pinMode(IN4 OUTPUT);
}

void loop()
{
digitalWrite(IN1 HIGH);
digitalWrite(IN2 LOW);
delay(2000);
digitalWrite(IN1 HIGH);
digitalWrite(IN2 HIGH);
delay(500);
digitalWrite(IN3 HIGH);
digitalWrite(IN4 LOW);
delay(2000);
digitalWrite(IN3 HIGH);
digitalWrite(IN4 HIGH);
delay(500);
digitalWrite(IN1 LOW);
digitalWrite(IN2 HIGH);
delay(2000);
digitalWrite(IN1 HIGH);
digitalWrite(IN2 HIGH);
delay(500);
digitalWrite(IN3 LOW);
digitalWrite(IN4 HIGH);
delay(2000);

digitalWrite(IN3 HIGH);
digitalWrite(IN4 HIGH);
delay(500);
}
//------------------------------------------------------------------------------------------------